Erde waterproof high-cover fitting instructions

Erde waterproof high-covers are quite simple to install. Here is a set of fitting instructions to help simplify it further.

First of all you should remember that the 102, 122 and 142 are slightly different to the rest of the Erde range. The 143 model trailer and above have black plastic caps covering holes in each of the trailers corner posts, this is where the frame of the high cover is slotted. You should be able to remove these by hand, if not, use a screwdriver to pop them out.

Trailer models 102, 122 and 142 do not have these plastic caps because the frame of the high cover actually sits on top of each corner of your trailer. The frame is held in place by the weight of the cover itself and the elastic cord that is stretched over all of the lashing points around the outside of the trailer.

The curved sections of frame are the main front and rear pieces, this is the same for all Erde trailer models. On the 143 trailer model and higher, insert one of these sections into the trailers two front corner posts. It is important to remember that there is a crease on each end of these sections that must face into the centre of the trailer.

When the front section of frame is in place it should look like this:

Now fit the rear section in the same way.

The front and rear sections of frame have two small slots along the top edge, this is where the side support pieces connect. Fit them now by slotting the flat ends of the side pieces into the front and rear sections of the frame. See the example below:

When you have fitted one side piece, fit the other in the same way. The frame should now be complete.

Unfold the waterproof cover and lay it on top of the frame. Using two hands, work your way around the trailer pulling the cover down over each corner.

Finally, hook the bungee cable from the cover over each one of the hooks around the outside of your trailer.

The waterproof high cover should now be complete and safely secured to the trailer. This whole process can be done in a couple minutes and should not require any tools.

Erde waterproof covers are supplied in two heights, 30cm and 60cm. The fitting process is the same for both.

For a wide selection of Erde accessories, including waterproof high-covers, please visit towingandtrailers.co.uk: